|
|
أدوات الموضوع | انواع عرض الموضوع |
رقم المشاركة : ( 1 )
|
|||||||||||
|
|||||||||||
Anntena
BEGINNER SECTION TELE-satellite International — www.TELE-satellite.comEletronicsThe low noise block is the actual heart of the satellite antenna. Basically, it’s a cavity resonator which receives at one end the focused satellite signals that are reflectedfrom the antenna and then processes these signals. Similar to an organ pipe it oscillates and triggers internal dipoles which convert the transmission energy into electrical signals. An additional electronic switch amplifiesthesesignals before they are sent to the coax cable and converts them into a lower frequency in order to minimise signal loss in the cables.Even though the de******ions may sound like there is a big difference between individual
models, most currently used LNB types use the same technology, the major distinguishing factor ****g the noise figurewhichhas been reduced to the theoretically lowest possible value of 0.3 dB in the most recent models. A universal LNB is used to divide the Ku band – which is predominantly used in Europe – into two partial frequency ranges.Each LNB can only be used for a single frequency band, because the S, C and Ku bands each require different cavity resonators. There are also individual types for linear and circular signals, which mainly differ in the way the internal dipoles are arranged.The power supply for the electronic switch is of particular interest. The power is provided by the receiver and transmitted over the coax cable. The coax cable therefore not only transmits the reception signals from the antenna to the receiver, but also the required operating power from the receiver to the LNB (together with additional control signals).Switching featureswhen changing channelsTransponders have one of two different polarisations (horizontal/vertical and left/right circular, respectively). That’s why the receiver has to tell the LNB the polarisation for any given signal, so that the appropriate dipole can be activated. The voltage of the power supply takes care of this: 14 V actiSatellite signals are very weak. That’s why we need a parabolic antenna to focus them and a low noise block, also known as LNB or sometimes LNBF, universal LNB or feedhorn mounted in its focal point to collect them. But what exactly happens inside this small component?the LNB with an individual coax cable, thus allowing signals to be received independently for each of these receivers.A quattro LNB with a switched output delivers all four possible signal configurations(horizontal/vertical and low/high band) simultaneously and is not suitable to be connected directly to a receiver. Its output signals are connected to a switching matrix. With the help of matrix cascades and intermediate amplifiers it is then possible to connect any desired number of receivers to this system.Multifeed for professionalsMultifeed means receiving signals from more than one satellite simultaneously with a fixedsatelliteantenna.Theadvantageofsucha solution is that switching between satellites takes place very quickly. However, several disadvantages or restriction are associated with multifeed receptionue to the reduced reception efficiencyitisnecessary to go for a larger dish.Not more than four satellites can be selected.The possible orbital range comprises not more than +/- 10 degrees (less rather than more). Satellites must be spaced at least What is an LNB – and what is it for?Heinz KoppitzBasic Functions vate the vertical polarisation, while 18 V activate the horizontal polarisation. Even though DiSEqC has developed into a very powerful control tool with more than 256 commands, it is still not used for switching between the polarisation levels.A universal LNB features a second switching mode for the extended Ku band. Since the frequency range of satellite receivers is not wide enough the actual frequency range has to be split up into two partial ranges. Switching between these ranges is controlled by a 22 kHz signal which the receiver also sends to the LNB when selecting a certain channel. This 22 kHz signal is also used as carrier frequency for DiSEqC control commands in more complex system configurations.TheseDiSEqCcommands serve for controlling multiswitches and antenna motors (see issue 189).Various designsThere are several design types for different purposes. The table lists the most common LNB types for the extended Ku band and indicated how they are used:TypeConnectionsFixed assemblyMotorised dishMultifeedSingle LNBOne receiverOne satelliteYes2 – 4Twin LNBTwo receiversOne satelliteNo2 – 4Quad LNBFour receiversOne satelliteNo2 – 4Quattro LNBMultiple usersOne satelliteNo2 – 4Octo LNBEight receiversOne satelliteNo2 – 4Monoblock 2Two receiversTwo satellitesNo2, fixedMonoblock 4Four receiversTwo satellitesNo2, fixedMonoblock 8Eight receiversTwo satellitesNo2, fixedSingle LNBs are suitable for individual reception. The reception principle of a single LNB is also included in flatantennas.Ifthereceivercomes with DiSEqC 1.2 and features the commands required to control a motorised dish, a single LNB in com***ation with a dish motor allow you to receive signals from any number of satellites. This makes for a very elegant configuration,exceptforthetimeyouhavetowait until the antenna has moved to the right position when selecting a channel from a different (i.e. not currently tuned into) satellite.All other designs are only suitable for fixedantennas. Twin, quad and octo LNBs are intended to support two, four or eight receivers. Each of these receivers is connected to three degrees apart from each otherA DiSEqC command is required for switching between signals.If more than one receiver is to be connected a signal matrix is required.It can be difficulttoproperly adjust the antenna.Practical monoblock LNBThis dual LNB is the simplest solution to achieve multifeed reception for two satellites. This design consists of two independent LNBs in a single case. The two LNBs can be automatically addressed with any DiSEqC 1.1 receiver. However, they are only available for satellites with a fixed3-degreeor6-degreespacing. In Europe, for example, there are monoblock single, twin and quad LNBs for the Ku band, which have a pre-definedspacingof 6 degrees (for Astra1/Hotbird or Astra2/Astra3A, for example).
|
6/1/2008, 11:37 PM | رقم المشاركة : ( 2 ) | |||
مـهـند س جـديـد
|
رد: Anntena
thans friend...............
|
|||
3/2/2008, 12:47 AM | رقم المشاركة : ( 3 ) | ||||
كبار الشخصيات
|
رد: Anntena
مشكووووووووووور
|
||||
5/4/2009, 12:04 PM | رقم المشاركة : ( 4 ) | ||||
مـهـند س مـمـيـز
|
رد: Anntena
مشكوووووووووووووووووور من القلب يا اخي العزيز وربنا يوفقق
|
||||
مواقع النشر (المفضلة) |
الذين يشاهدون محتوى الموضوع الآن : 1 ( الأعضاء 0 والزوار 1) | |
|
|
Google Adsense Privacy Policy | سياسة الخصوصية لـ جوجل ادسنس
^-^ جميع آلمشآركآت آلمكتوبهـ تعبّر عن وجهة نظر صآحبهآ ,, ولا تعبّر بأي شكلـ من آلأشكآل عن وجهة نظر إدآرة آلمنتدى ~